Flow Rate |
---|
Oil-Rite manufactures Lubrication Systems specifically to customer requirements. All systems are engineered, designed, manufactured and fully tested at Oil-Rite. This is an example of a custom built Circulating Oil System.
This Circulating Oil System is equipped with a cast iron pump providing .55 GPM minimum at 35 PSI. The 1/3 HP, 1725 RPM, TEFC motor is operated by 3 phase power at 230/460V 60Hz.
The 10 gallon capacity reservoir is constructed of welded steel. A top filler cap makes filling the reservoir quick and simple. The filler cap is equipped with an air filter and liquid strainer to help maintain liquid quality. A baffle in the tank separates sediment and reduces turbulence. There are (2) 3/4” female NPT returns and (2) 1/2” female NPT drains.
The 23 micron, 1000 beta filter near the outlet helps maintain liquid quality. There is also a 100 mesh stainless steel suction filter within the reservoir. A differential pressure gage and switch is provided to monitor circulation and signal an alarm caused by high levels of filter contamination.
An air cooled heat exchanger maintains a constant oil supply temperature. This system was designed for an application where oil circulates in at about 225° F and out at 120° F. The heat exchanger’s fan is operated with a 1/4 HP, 1725 RPM, TENV motor operated by 3 phase power at 230/460V 60Hz. A temperature switch, adjustable from 75° to 200° F, is used to control the heat exchanger fan. The switch is housed in a NEMA 4 enclosure.
Heaters can maintain a certain liquid temperature and assist in cold weather start-ups. This Circulating Oil System features a 1500 watt immersion heater. The heater is mounted on the side of the reservoir and housed in a NEMA 4 enclosure. It has an integral thermostat adjustable from 60° to 250° F.
Additional controls include:
· A low level switch in the reservoir that can be wired to shut down machinery or turn on warning devices when the liquid supply fails or recedes to a predetermined level. The wiring is accessed using the conduit box and relay.
All Circulating Oil Systems are quoted specifically to customer requirements. Pricing can be determined only after the Circulating Oil System Request Form (found on this page) is completed. Contact the bearing manufacturer for information on the flow rate and fluid required.
Delivery is dependent upon supplier availability, lead times range from 4 to 10 weeks.
SIMILAR PRODUCTS
YC818-1
Resources
4325 Clipper Drive
Manitowoc, WI 54220
© Oil-Rite, LLC. All Rights Reserved. Privacy Policy | Terms of Service | Sitemap | Website Design by Lion Tree Group